SI3015-F-FS View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
Manufacturer
SI3015-F-FS Datasheet PDF : 68 Pages
| |||
Si2403
Table 12. Result Codes1
Numeric2
Meaning
Verbal Response
X0 X1 X2 X3 X4 X5
0 Command was successful OK
XXXXXX
1 Link established at 300 bps CONNECT
or higher
XXXXXX
2
Incoming ring detected
RING
XXXXXX
3 Link dropped
NO CARRIER
XXXXXX
4 Command failed
ERROR
XXXXXX
5
Link establish at 1200
CONNECT 1200
XXXXX
6
Dial tone not present
NO DIALTONE
X
XX
7
Line busy
BUSY
XXX
9 Ringback detected
RINGING
X
10 Link established at 2400 CONNECT 2400
XXXXX
30 Caller ID mark detected
CIDM
XXXXXX
31 Hookswitch flash detected FLASH
XXXXXX
32 UK CID State Tone Alert STAS
Signal detected
33 Overcurrent condition
X3
XXXXXX
XXXXXX
40 Blacklist is full
BLACKLIST FULL (enabled
via S42 register)
XXXXXX
41 Attempted number is black- BLACKLISTED (enabled via X X X X X X
listed.
S42 register)
42 No phone line present
NO LINE (enabled via %Vn
commands)
XXXXXX
43 Telephone line is in use
LINE IN USE (enabled via
%Vn commands)
XXXXXX
44 A polarity reversal was
detected
POLARITY REVERSAL
(enabled via G modifier)
XXXXXX
45 A polarity reversal was NOT NO POLARITY REVERSAL X X X X X X
detected
(enabled via G modifier)
70 No protocol
PROTOCOL: NONE
Set with \V command.
75 Link established at 75
CONNECT 75
XXXXX
77 V.42 protocol
PROTOCOL: V42
Set with \V command.
80 MNP2 protocol
PROTOCOL:
ALTERNATE, + CLASS 2
Set with \V command.
81 MNP3 protocol
PROTOCOL:
ALTERNATE, + CLASS 3
Set with \V command.
82 MNP4 protocol
PROTOCOL:
ALTERNATE, + CLASS 4
Set with \V command.
102 DTMF dial attempted on a UNOBTAINABLE NUMBER
pulse dial only line
XXXXXX
Notes:
1. The connect messages shown in this table are sent when link negotiation is complete.
2. Numeric result codes are of the format: Result code <CR>.
3. X is the only verbal response code that does not follow the <CR><LF>Result Code<CR><LF> standard. There is no
leading <CR><LF>.
32
Rev. 1.2
Share Link: 