TDA9110 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
Manufacturer
TDA9110 Datasheet PDF : 29 Pages
| |||
TDA9110
OPERATING DESCRIPTION (continued)
Typical maximum and minimum frequency, at 25oC
and without any correction (S correction or C cor-
rection), can be calculated by :
f(Max.) = 2.5 x f0 and f(Min.) = 0.33 x f0
If S or C corrections are applied, these values are
slighty affected.
If a synchronization pulse is applied, the internal
oscillator is automaticaly caught but the amplitude
is no more constant. An internal correction is acti-
vated to adjust it in less than a half a second : the
highest voltage of the ramp Pin 22 is sampled on
the sampling capacitor connected on Pin 20 at
each clock pulse and a transconductanceamplifier
generates the charge current of the capacitor. The
ramp amplitude becomes again constant.
The read status register enables to have the verti-
cal Lock-Unlock and the vertical Synchro Polarity
informations.
We recommand to use a AGC capacitor with low
leakage current. A value lower than 100nA is man-
datory.
A good stability of the internal closed loop is
reached by a 470nF ± 5% capacitor value on
Pin 20 (VAGC).
III.6 - I2C Control Adjustments
Then, S and C correction shapes can be added to
this ramp. These frequence independent S and C
corrections are generated internally. Their ampli-
tudes are adjustable by their respective I2C regis-
ter. They can also be inhibited by their Select bit.
Finally, the amplitude of this S and C corrected
ramp can be adjusted by the vertical ramp ampli-
tude control register.
The adjusted ramp is available on Pin 23 (VOUT) to
drive an external power stage.
The gain of this stage is typically 25% depending
on its register value.
The DC value of this ramp is driven by its own I2C
register (vertical Position). Its value is
VCDOUT = 7/16 ⋅ VREF ± 300mV.
The VDCOUT voltage is correlated with DC value of
VOUT. It increases the accuracy when temperature
varies.
By using the vertical moire, VDCOUT can be modu-
lated from frame to frame. This function is intended
to correct slightly the vertical video line to line
period from actual CRT line to line width.
III.7 - Basic Equations
In first approximation,the amplitude of the ramp on
Pin 23 (Vout) is :
VOUT - VMID = (VOSC - VMID) ⋅ (1 + 0.25 (VAMP))
with VMID = 7/16 ⋅ VREF ; typically 3.5V, the middle
value of the ramp on Pin 22
VOSC = V22 , ramp with fixed amplitude
VAMP is -1 for minimum vertical amplitude register
value and +1 for maximum
On VDCOUT, the voltage (in volts) is calculated by :
VDCOUT = VMID + 0.3 (VPOS)
with VPOS equals -1 for minimum vertical position
register value and +1 for maximum
The current available on Pin 22 is :
IOSC
=
3
8
⋅
VREF ⋅
COSC
⋅
f
with COSC : capacitor connected on Pin 22
f : synchronization frequency
23/29
Share Link: 