ST72361J4-AUTO View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST72361J4-AUTO

8-bit MCU for automotive with Flash or ROM, 10-bit ADC, 5 timers, SPI, LINSCI™

STMicroelectronics 

Central processing unit

4

Central processing unit

ST72361xx-Auto

4.1

Introduction

This CPU has a full 8-bit architecture and contains six internal registers allowing efficient

8-bit data manipulation.

4.2

Main features

● Enable executing 63 basic instructions

● Fast 8-bit by 8-bit multiply

● 17 main addressing modes (with indirect addressing mode)

● Two 8-bit index registers

● 16-bit stack pointer

● Low power HALT and WAIT modes

● Priority maskable hardware interrupts

● Non-maskable software/hardware interrupts

4.3

4.3.1

4.3.2

4.3.3

CPU registers

The six CPU registers shown in Figure 8 are not present in the memory mapping and are

accessed by specific instructions.

Accumulator (A)

The Accumulator is an 8-bit general purpose register used to hold operands and the results

of the arithmetic and logic calculations and to manipulate data.

Index registers (X and Y)

These 8-bit registers are used to create effective addresses or as temporary storage areas

for data manipulation. (The Cross-Assembler generates a precede instruction (PRE) to

indicate that the following instruction refers to the Y register.)

The Y register is not affected by the interrupt automatic procedures.

Program counter (PC)

The program counter is a 16-bit register containing the address of the next instruction to be

executed by the CPU. It is made of two 8-bit registers PCL (Program Counter Low which is

the LSB) and PCH (Program Counter High which is the MSB).

34/279

Doc ID 12468 Rev 3

Share Link: