GAL16V8C-5LP データシートの表示（PDF） - Lattice Semiconductor
部品番号
コンポーネント説明
メーカー
GAL16V8C-5LP Datasheet PDF : 23 Pages
| |||
SSpepceicfiicfiactaiotinosnsGGAAL1L166VV88B
ABSOLUTE MAXIMUM RATINGS(1)
RECOMMENDED OPERATING COND.
Supply voltage V ....................................... –0.5 to +7V
CC
Input voltage applied .......................... –2.5 to V +1.0V
CC
Off-state output voltage applied .......... –2.5 to V +1.0V
CC
Storage Temperature ................................. –65 to 150°C
Ambient Temperature with
Power Applied ........................................ –55 to 125°C
1.Stresses above those listed under the “Absolute Maximum
Ratings” may cause permanent damage to the device. These
are stress only ratings and functional operation of the device
at these or at any other conditions above those indicated in the
operational sections of this specification is not implied (while
programming, follow the programming specifications).
Commercial Devices:
Ambient Temperature (TA) ............................... 0 to 75°C
Supply voltage (V )
CC
with Respect to Ground ..................... +4.75 to +5.25V
Industrial Devices:
Ambient
Temperature
(T )
A
........................... –40
to
85°C
Supply voltage (V )
CC
with Respect to Ground ..................... +4.50 to +5.50V
DC ELECTRICAL CHARACTERISTICS
Over Recommended Operating Conditions (Unless Otherwise Specified)
SYMBOL PARAMETER
CONDITION
MIN. TYP.3 MAX. UNITS
VIL
Input Low Voltage
VIH
Input High Voltage
IIL1
Input or I/O Low Leakage Current
0V ≤ VIN ≤ VIL (MAX.)
IIH
Input or I/O High Leakage Current
3.5V ≤ VIN ≤ VCC
VOL
Output Low Voltage
IOL = MAX. Vin = VIL or VIH
VOH Output High Voltage
IOH = MAX. Vin = VIL or VIH
IOL
Low Level Output Current
IOH
High Level Output Current
IOS2
Output Short Circuit Current
VCC = 5V
VOUT = 0.5V
T=
A
25°C
COMMERCIAL
ICC
Operating Power VIL = 0.5V VIH = 3.0V
L -7/-10
Supply Current
ftoggle = 15MHz Outputs Open
L -15/-25
Vss – 0.5 —
2.0
—
—
—
—
—
—
—
2.4
—
—
—
—
—
–30
—
—
75
—
75
Q -15/-25
—
45
INDUSTRIAL
ICC
Operating Power
Supply Current
VIL = 0.5V VIH = 3.0V
ftoggle = 15MHz Outputs Open
L -10/-15/-25 —
75
Q -20/-25
—
45
0.8
V
Vcc+1 V
–100 µA
10
µA
0.5
V
—
V
24
mA
–3.2 mA
–150 mA
115 mA
90
mA
55
mA
130 mA
65
mA
1) The leakage current is due to the internal pull-up resistor on all pins. See Input Buffer section for more information.
2) One output at a time for a maximum duration of one second. Vout = 0.5V was selected to avoid test problems caused by tester
ground degradation. Guaranteed but not 100% tested.
3) Typical values are at Vcc = 5V and TA = 25 °C
3-76
1996 Data Book
Share Link: 