CS61583 查看數據表（PDF） - Cirrus Logic

零件编号

产品描述 (功能)

生产厂家

CS61583

Dual T1/E1 Line Interface

Cirrus Logic 

CS61583

resistor must be connected from BGREF to

ground to provide an internal current reference.

De-coupling and filtering of the power supplies is

crucial for the proper operation of the analog cir-

cuits. A capacitor should be connected between

each supply and its respective ground. For capaci-

tors smaller than 1 µF, use mylar or ceramic

capacitors and place them as close as possible to

their respective power supply pins. Wire-wrap

bread boarding of the line interface is not recom-

mended because lead resistance and inductance

defeat the function of the de-coupling capacitors.

Crystal Oscillator Specifications

When a reference clock signal is not available, a

CMOS crystal oscillator operating at either the

1X or 8X rate can be connected at the REFCLK

pin. The oscillator must have a minimum symme-

try of 40-60% and minimum stability of ±100

ppm for T1 and E1 applications. Based on these

specifications, some suggested crystal oscillators

for use with the CS61583 are shown in Table A2.

Manufacturer Part Number Contact Number

Comclok

CT31CH (800) 333-9825

CTS CXO-65HG-5-I (815) 786-8411

M-tron

MH26TAD (800) 762-8800

SaRonix

NTH250A (800) 227-8974

Notes:

Frequency tolerances are ±32 ppm with a -40 to +85 °C

operating temperature range.

All are 8-pin DIP packages and can be tristated.

Table A2. Suggested Crystal Oscillators

Turns Ratio

Primary inductance

Primary leakage

inductance

Secondary leakage

inductance

Interwinding

capacitance

ET-constant

1:1.15 step-up transmit

1:1.15 step-down receive

1.5 mH min at 772 kHz

0.3 µH max at 772 kHz

with secondary shorted

0.4 µH max at 772 kHz

18 pF max, primary to

secondary

16 V-µs min

Table A3. Transformer Specifications

Designing for AT&T 62411

For additional information on the requirements of

AT&T 62411 and the design of an appropriate

system synchronizer, refer to the Crystal Semi-

conductor Application Notes "AT&T 62411

Design Considerations - Jitter and Synchroniza-

tion" and "Jitter Testing Procedures for

Compliance with AT&T 62411."

Line Protection

Secondary protection components can be added

to the line interface circuitry to provide lightning

surge and AC power-cross immunity. For addi-

tional information on the different electrical

safety standards and specific application circuit

recommendations, refer to the Crystal Semicon-

ductor Application Note "Secondary Line

Protection for T1 and E1 Line Cards."

Transformers

Recommended transformer specifications are

shown in Table A3. Based on these specifications,

the transformers recommended for use with the

CS61583 are listed in Table A4.

32

DS172PP5

Share Link: