B0530W 查看數據表（PDF） - Linear Technology

零件编号

产品描述 (功能)

生产厂家

B0530W

Step-Down 1A LED Driver

Linear Technology 

LT3474/LT3474-1

APPLICATIONS INFORMATION

To minimize the error from variations in VADJ pin current,

use resistors with a parallel resistance of less than 4k. Use

resistors with a series resistance of 5.11k or greater so as

not to exceed the 250μA current limit on the REF pin.

Dimming Control

There are several different types of dimming control cir-

cuits. One dimming control circuit (Figure 6) changes the

voltage on the VADJ pin by tying a low on-resistance FET to

the resistor divider string. This allows the selection of two

different LED currents. For reliable operation, program an

LED current of no less than 35mA. The maximum current

dimming ratio (IRATIO) can be calculated from the maxi-

mum LED current (IMAX) and the minimum LED current

(IMIN) as follows:

IMAX

IMIN

= IRATIO

Another dimming control circuit (Figure 7) uses the PWM

pin and an external NFET tied to the cathode of the LED.

When the PWM signal goes low, the NFET turns off, turn-

ing off the LED and leaving the output capacitor charged.

The PWM pin is pulled low as well, which disconnects the

VC pin, storing the voltage in the capacitor tied there. Use

the C-RC string (tied to the VC pin) shown in Figure 7 for

proper operation during start-up. When the PWM pin goes

high again, the LED current returns rapidly to its previous

on state since the compensation and output capacitors are

at the correct voltage. This fast settling time allows The

LT3474 to maintain diode current regulation with PWM

pulse widths as short as 40μs. If the NFET is omitted and

the cathode of the LED is instead tied to GND, use PWM

pulse widths of 1ms or greater. The maximmum PWM

dimming ratio (PWMRATIO) can be calculated from the

maximum PWM period (tMAX) and minimum PWM pulse

width (tMIN) as follows:

tMAX

tMIN

= PWMRATIO

Total dimming ratio (DIMRATIO) is the product of the PWM

dimming ratio and the current dimming ratio.

Example: IMAX = 1A, IMIN = 0.1A, tMAX = 12ms, tMIN = 40μs

IRATIO

=

1A

0.1A

=

10

:

1

PWMRATIO

=

12ms

40μs

=

300

:1

DIMRATIO = 10 • 300 = 3000:1

REF

R1

LT3474

VADJ

R2

GND

DIM

3474 F05

Figure 6. Dimming with an NFET and Resistor Divider

PWM

60Hz TO

10kHz

PWM

LT3474

LED

GND

3.3nF 10k

0.1μF

3474 F06

Figure 7. Dimming Using PWM Signal

3474fd

16

Share Link: