STM32F301C8T7(2014) 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

STM32F301C8T7
(Rev.:2014)

ARM® Cortex®-M4 32-bit MCU+FPU, up to 64 KB Flash, 16 KB SRAM, ADC, DAC, COMP, Op-Amp, 2.0 – 3.6 V

STMicroelectronics 

STM32F301x6 STM32F301x8

Electrical characteristics

1. All main power (VDD, VDDA) and ground (VSS and VSSA) pins must always be connected to the external power supply, in the

permitted range.

2. This current consumption must be correctly distributed over all I/Os and control pins.The total output current must not be

sunk/sourced between two consecutive power supply pins referring to high pin count LQFP packages.

3. Positive injection is not possible on these I/Os and does not occur for input voltages lower than the specified maximum

value.

4. A positive injection is induced by VIN > VDD while a negative injection is induced by VIN< VSS. IINJ(PIN) must never be

exceeded. Refer to Table 20: Voltage characteristics for the maximum allowed input voltage values.

5. A positive injection is induced by VIN > VDDA while a negative injection is induced by VIN< VSS. IINJ(PIN) must never be

exceeded. Refer also to Table 20: Voltage characteristics for the maximum allowed input voltage values. Negative injection

disturbs the analog performance of the device. See note (2) below Table 65.

6. When several inputs are submitted to a current injection, the maximum IINJ(PIN) is the absolute sum of the positive and

negative injected currents (instantaneous values).

Symbol

TSTG

TJ

Table 22. Thermal characteristics

Ratings

Storage temperature range

Maximum junction temperature

Value

Unit

–65 to +150 °C

150

°C

DocID025146 Rev 3

55/132

112

Share Link: