STPCC03 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STPCC03

PC Compatible Embeded Microprocessor

STMicroelectronics 

6.3.7 Data Read (MD[63:0])

The data read simulation circuit is shown below..

Figure 6-17. Data read equivalent circuit

DIMM1

SDRAM

DQ

10W

10mm

6.3.8 Data Mask (DQM[7:0])

The data mask load is quite similar to that of the

data signals.

6.3.9 Summary

For unbuffered DIMMs the address/control signals

will be the most critical for timing unless the mem-

ory controller can be designed to set up these sig-

nals one cycle in advance. The simulations show

that for these signals the best way to drive them is

to use a parallel termination. For applications

where speed is not so critical series termination

can be used as this will save power. Using a low

impedance such as 50W for these critical traces is

recommended as it both reduces the delay and

the overshoot.

The other memory interface signals will typically

be not as critical as the address/control signals for

unbuffered DIMMs. When using registered DIMMs

the other signals will probably be just as critical as

the address/control signals so to gain maximum

benefit from using registered DIMMs the timings

should also be considered in that situation. Using

lower impedance traces is also beneficial for the

other signals but if their timing is not as critical as

the address/control signals they could use the de-

fault value. Using a lower impedance implies us-

ing wider traces which may have an impact on the

routing of the board.

BOARD LAYOUT

125mm

(0.9ns)

47/51

Release B

This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change without notice.

Share Link: