M24128-DRHMTP View Datasheet(PDF) - STMicroelectronics
Part Name
Description
Manufacturer
M24128-DRHMTP Datasheet PDF : 46 Pages
| |||
M24128-BW M24128-BR M24128-BF M24128-DF
DC and AC parameters
Symbol
Table 14. DC characteristics (M24128-BR device grade 6)
Parameter
Test conditions(1) (in addition to
those in Table 7)
Min.
Max. Unit
ILI
Input leakage current
VIN = VSS or VCC, device in
( E0, E1, E2, SCL, SDA) Standby mode
ILO Output leakage current
SDA in Hi-Z, external voltage
applied on SDA: VSS or VCC
-
± 2 µA
-
± 2 µA
ICC Supply current (Read)
VCC = 1.8 V, fc= 400 kHz
fc= 1 MHz(2)
-
0.8 mA
-
2.5 mA
ICC0
Supply current (Write)(3)
During tW
1.8 V ≤ VCC ≤ 2.5 V
ICC1 Standby supply current
Device not selected(6),
VIN = VSS or VCC, VCC = 1.8 V
Input low voltage
VIL
(SCL, SDA, WC, E2, E1,
E0)(7)
1.8 V ≤ VCC < 2.5 V
-
2(4)(5) mA
-
1
µA
–0.45 0.25 VCC V
Input high voltage
(SCL, SDA)
VIH Input high voltage
(WC, E2, E1, E0)(8)
1.8 V ≤ VCC < 2.5 V
1.8 V ≤ VCC < 2.5 V
0.75 VCC 6.5
V
0.75 VCC VCC+ 0.6 V
VOL Output low voltage
IOL = 1 mA, VCC = 1.8 V(9)
-
0.2
V
1.
If the application uses the voltage range R device
please refer to Table 13 instead of this table.
with
2.5
V
<
Vcc
<
5.5
V
and
-40
°C
<
TA
<
+85
°C,
2.
Only for devices
Table 17)
identified
with
process
letter
K
or
T
(devices
operating
at
fC
max
=
1
MHz,
see
note
(1)
in
3. For devices identified with process letter K or T
4. Characterized value, not tested in production.
5. 3 mA for previous devices identified by process letter A.
6. The device is not selected after power-up, after a Read instruction (after the Stop condition), or after the
completion of the internal write cycle tW (tW is triggered by the correct decoding of a Write instruction).
7. Ei inputs should be tied to Vss (see Section 2.3).
8. Ei inputs should be tied to Vcc (see Section 2.3).
9. IOL = 0.7 mA for devices identified by process letter A.
DocID16892 Rev 30
27/46
45
Share Link: 