M24128-DRHMTP View Datasheet(PDF) - STMicroelectronics
Part Name
Description
Manufacturer
M24128-DRHMTP Datasheet PDF : 46 Pages
| |||
DC and AC parameters
M24128-BW M24128-BR M24128-BF M24128-DF
Table 15. DC characteristics (M24128-BF, M24128-DF, device grade 6)
Symbol
Parameter
Test conditions(1) (in addition to
those in Table 8)
Min.
Max. Unit
ILI
Input leakage current
(E0, E1, E2, SCL,
SDA)
VIN = VSS or VCC
device in Standby mode
-
ILO
Output leakage current
SDA in Hi-Z, external voltage applied
on SDA: VSS or VCC
-
± 2 µA
± 2 µA
VCC = 1.6 V or 1.7 V, fC = 400 kHz
-
0.8
ICC Supply current (Read)
fC = 1 MHz(2)
mA
-
2.5
ICC0 Supply current (Write) During tWVCC < 2.5 V
Device not selected(5),
ICC1 Standby supply current VIN = VSS or VCC, VCC = 1.6 V or
1.7 V
-
2(3)(4) mA
-
1
µA
VIL
Input low voltage
(SCL, SDA, WC, Ei)(6)
VCC < 2.5 V
–0.45 0.25 VCC V
Input high voltage
(SCL, SDA)
VIH Input high voltage
(WC, E2, E1, E0)(7)
VCC < 2.5 V
VCC < 2.5 V
0.75 VCC 6.5
V
0.75 VCC VCC+ 0.6
VOL Output low voltage
IOL =1mA(8),
VCC = 1.6 V or 1.7 V
-
0.2
V
1.
If the application uses the voltage range F device
please refer to Table 13 instead of this table.
with
2.5
V
<
VCC
<
5.5
V
and
-40
°C
<
TA
<
+85
°C,
2. Only for devices identified by process letter K or T (see Table 17).
3. Characterized value, not tested in production.
4. 3 mA for previous devices identified by process letter A.
5. The device is not selected after power-up, after a Read instruction (after the Stop condition), or after the
completion of the internal write cycle tW (tW is triggered by the correct decoding of a Write instruction).
6. Ei inputs should be tied to VSS(see Section 2.3).
7. Ei inputs should be tied to VCC (see Section 2.3).
8. IOL = 0.7 mA for devices identified by process letters A.
28/46
DocID16892 Rev 30
Share Link: 