TS80C31X2-LIB View Datasheet(PDF) - Atmel Corporation
Part Name
Description
Manufacturer
TS80C31X2-LIB Datasheet PDF : 42 Pages
| |||
13. Power-Off Flag
The power-off flag allows the user to distinguish between a “cold start” reset and a “warm start”
reset.
A cold start reset is the one induced by VCC switch-on. A warm start reset occurs while VCC is still
applied to the device and could be generated for example by an exit from power-down.
The power-off flag (POF) is located in PCON register (See Table 13-1.). POF is set by hardware
when VCC rises from 0 to its nominal voltage. The POF can be set or cleared by software allow-
ing the user to determine the type of reset.
The POF value is only relevant with a Vcc range from 4.5V to 5.5V. For lower Vcc value, reading
POF bit will return indeterminate value.
Table 13-1. PCON Register -- PCON - Power Control Register (87h)
7
6
5
4
3
2
1
0
SMOD1
SMOD0
-
POF
GF1
GF0
PD
IDL
Bit
Bit
Number Mnemonic
Description
7
SMOD1
Serial port Mode bit 1
Set to select double baud rate in mode 1, 2 or 3.
Serial port Mode bit 0
6
SMOD0 Clear to select SM0 bit in SCON register.
Set to to select FE bit in SCON register.
5
-
Reserved
The value read from this bit is indeterminate. Do not set this bit.
Power-Off Flag
4
POF Clear to recognize next reset type.
Set by hardware when VCC rises from 0 to its nominal voltage. Can also be set by software.
General purpose Flag
3
GF1 Cleared by user for general purpose usage.
Set by user for general purpose usage.
General purpose Flag
2
GF0 Cleared by user for general purpose usage.
Set by user for general purpose usage.
Power-Down mode bit
1
PD Cleared by hardware when reset occurs.
Set to enter power-down mode.
Idle mode bit
0
IDL Clear by hardware when interrupt or reset occurs.
Set to enter idle mode.
Reset Value = 00X1 0000b
Not bit addressable
24 AT/TS80C31X2
4428D–8051–08/05
Share Link: 