ATMEGA64L-8MI View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

ATMEGA64L-8MI

8-bit AVR® Microcontroller with 64K Bytes In-System Programmable Flash

Atmel Corporation 

Reading the Flash

Programming the EEPROM

Reading the EEPROM

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Flash read using programming instruction 3a.

3. Load address using programming instructions 3b and 3c.

4. Read data using programming instruction 3d.

5. Repeat steps 3 and 4 until all data have been read.

A more efficient data transfer can be achieved using the PROG_PAGEREAD

instruction:

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Flash read using programming instruction 3a.

3. Load the page address using programming instructions 3b and 3c. PCWORD

(refer to Table 124 on page 296) is used to address within one page and must be

written as 0.

4. Enter JTAG instruction PROG_PAGEREAD.

5. Read the entire page by shifting out all instruction words in the page, starting

with the LSB of the first instruction in the page and ending with the MSB of the

last instruction in the page. Remember that the first eight bits shifted out should

be ignored.

6. Enter JTAG instruction PROG_COMMANDS.

7. Repeat steps 3 to 6 until all data have been read.

Before programming the EEPROM, a Chip Erase must be performed. See “Performing

Chip Erase” on page 322.

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable EEPROM write using programming instruction 4a.

3. Load address high byte using programming instruction 4b.

4. Load address low byte using programming instruction 4c.

5. Load data using programming instructions 4d and 4e.

6. Repeat steps 4 and 5 for all data bytes in the page.

7. Write the data using programming instruction 4f.

8. Poll for EEPROM write complete using programming instruction 4g, or wait for

tWLRH (refer to Table 1 on page 305).

9. Repeat steps 3 to 8 until all data have been programmed.

Note that the PROG_PAGELOAD instruction can not be used when programming the

EEPROM.

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable EEPROM read using programming instruction 5a.

3. Load address using programming instructions 5b and 5c.

4. Read data using programming instruction 5d.

5. Repeat steps 3 and 4 until all data have been read.

Note that the PROG_PAGEREAD instruction can not be used when reading the

EEPROM

324 ATmega64(L)

2490G–AVR–03/04

Share Link: