C8051F911-GM View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
Manufacturer
C8051F911-GM
Silicon Laboratories
C8051F911-GM Datasheet PDF : 318 Pages
| |||
C8051F91x-C8051F90x
whether the CPU accesses the upper 128 bytes of data memory space or the SFRs. Instructions that use
direct addressing will access the SFR space. Instructions using indirect addressing above 0x7F access the
upper 128 bytes of data memory. Figure 9.1 illustrates the data memory organization of the C8051F91x-
C8051F90x.
9.2.1.1. General Purpose Registers
The lower 32 bytes of data memory, locations 0x00 through 0x1F, may be addressed as four banks of
general-purpose registers. Each bank consists of eight byte-wide registers designated R0 through R7.
Only one of these banks may be enabled at a time. Two bits in the program status word, RS0 (PSW.3) and
RS1 (PSW.4), select the active register bank (see description of the PSW in SFR Definition 8.6). This
allows fast context switching when entering subroutines and interrupt service routines. Indirect addressing
modes use registers R0 and R1 as index registers.
9.2.1.2. Bit Addressable Locations
In addition to direct access to data memory organized as bytes, the sixteen data memory locations at 0x20
through 0x2F are also accessible as 128 individually addressable bits. Each bit has a bit address from
0x00 to 0x7F. Bit 0 of the byte at 0x20 has bit address 0x00 while bit7 of the byte at 0x20 has bit address
0x07. Bit 7 of the byte at 0x2F has bit address 0x7F. A bit access is distinguished from a full byte access by
the type of instruction used (bit source or destination operands as opposed to a byte source or
destination).
The MCS-51™ assembly language allows an alternate notation for bit addressing of the form XX.B where
XX is the byte address and B is the bit position within the byte. For example, the instruction:
MOV C, 22.3h
moves the Boolean value at 0x13 (bit 3 of the byte at location 0x22) into the Carry flag.
Rev. 1.0
109
Share Link: 