CS8900A
Crystal LAN™ Ethernet Controller
ing bus signals are tied to the following pins:
Bus signal
IRQ5
IRQ10
IRQ11
IRQ12
Typical pin connection
INTRQ3
INTRQ0
INTRQ1
INTRQ2
See Section 3.2 on page 18.
After reset, if no EEPROM is found by the CS8900A, then the register has the following initial state, which corre-
sponds to placing all the INTRQ pins in a high-impedance state. If an EEPROM is found, then the register's initial
value may be set by the EEPROM. See Section 3.3 on page 19.
Reset value is: XXXX XXXX XXXX X100
4.3.4 DMA Channel Number
(Read/Write, Address: PacketPage base + 0024h)
Address 0025h
00h
Address 0024h
DMA channel assignment:
0000 0000b= pin DMRQ0 and DMACK0
0000 0001b= pin DMRQ1 and DMACK1
0000 0010b= pin DMRQ2 and DMACK2
0000 0011b= All DMRQ pins high-impedance
The DMA Channel register defines the DMA pins selected by the CS8900A. In the typical application, the following
bus signals are tied to the following pins:
Bus signal
DRQ5
DACK5
DRQ6
DACK6
DRQ7
DACK7
Typical pin connection
DMRQ0
DMACK0
DMRQ1
DMACK1
DMRQ2
DMACK2
See Section 3.2 on page 18 and Section 5.3 on page 90.
After reset, if no EEPROM is found by the CS8900A, then the register has the following initial state which corre-
sponds to setting all DMRQ pins to high-impedance. If a EEPROM is found, then the register's initial value may be
set by the EEPROM. See Section 3.3 on page 19.
Reset value is: XXXX XXXX XXXX XX11
4.3.5 DMA Start of Frame
(Read only, Address: PacketPage base + 0026h)
Address 0027h
Most significant byte of offset value
Address 0026h
Least significant byte of offset value
The DMA Start of Frame Register contains a 16-bit value which defines the offset from the DMA base address to
the start of the most recently transferred received frame. See Section 5.3 on page 90.
CIRRUS LOGIC PRODUCT DATASHEET
DS271F4
45