Enhanced Super I/O Controller with Fast IR
Datasheet
Chapter 20 Operational Description
20.1
Maximum Guaranteed Ratings*
Operating Temperature Range .................................................................................................. 0oC to +70oC
Storage Temperature Range .................................................................................................. -55o to +150oC
Lead Temperature Range (soldering, 10 seconds)............................................................................. +325oC
Positive Voltage on any pin, with respect to Ground.........................................................................Vcc+0.3V
Negative Voltage on any pin, with respect to Ground ............................................................................ -0.3V
Maximum Vcc............................................................................................................................................ +7V
*Stresses above those listed above could cause permanent damage to the device. This is a stress rating
only and functional operation of the device at any other condition above those indicated in the operation
sections of this specification is not implied.
Note:
When powering this device from laboratory or system power supplies, it is important that the Absolute
Maximum Ratings not be exceeded or device failure can result. Some power supplies exhibit voltage
spikes on their outputs when the AC power is switched on or off. In addition, voltage transients on the AC
power line may appear on the DC output. If this possibility exists, it is suggested that a clamp circuit be
used.
20.2 DC Electrical Characteristics
(TA = 0°C - 70°C, Vcc = +5 V ± 10%)
PARAMETER
I Type Input Buffer
SYMBOL MIN TYP MAX UNITS
COMMENTS
Low Input Level
VILI
0.8
V
TTL Levels
High Input Level
VIHI
2.0
V
IS Type Input Buffer
Low Input Level
VILIS
0.8
V
Schmitt Trigger
High Input Level
VIHIS
2.2
V
Schmitt Trigger
Schmitt Trigger Hysteresis
ICLK Input Buffer
VHYS
250
mV
Low Input Level
VILCK
0.4
V
High Input Level
VIHCK
2.2
V
ICLK2 Input Buffer
Input Level
500
mV V P - P
SMSC FDC37C672
Page 143
DATASHEET
Rev. 10-29-03