PIC18LF8410-I/PTQTP View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC18LF8410-I/PTQTP

64/80-Pin Flash Microcontrollers with nanoWatt Technology

Microchip Technology 

PIC18F6310/6410/8310/8410

4.2 Master Clear (MCLR)

The MCLR pin provides a method for triggering a hard

external Reset of the device. A Reset is generated by

holding the pin low. PIC18 Extended MCU devices

have a noise filter in the MCLR Reset path which

detects and ignores small pulses.

The MCLR pin is not driven low by any internal Resets,

including the WDT.

In PIC18F6310/6410/8310/8410 devices, the MCLR

input can be disabled with the MCLRE configuration bit.

When MCLR is disabled, the pin becomes a digital

input. See Section 10.7 “PORTG, TRISG and LATG

Registers” for more information.

4.3 Power-on Reset (POR)

A Power-on Reset pulse is generated on-chip

whenever VDD rises above a certain threshold. This

allows the device to start in the initialized state when

VDD is adequate for operation.

To take advantage of the POR circuitry, tie the MCLR

pin through a resistor (1 kΩ to 10 kΩ) to VDD. This will

eliminate external RC components usually needed to

create a Power-on Reset delay. A minimum rise rate for

VDD is specified (parameter D004). For a slow rise

time, see Figure 4-2.

When the device starts normal operation (i.e., exits the

Reset condition), device operating parameters

(voltage, frequency, temperature, etc.) must be met to

ensure operation. If these conditions are not met, the

device must be held in Reset until the operating

conditions are met.

POR events are captured by the POR bit (RCON<1>).

The state of the bit is set to ‘0’ whenever a POR occurs;

it does not change for any other Reset event. POR is

not reset to ‘1’ by any hardware event. To capture

multiple events, the user manually resets the bit to ‘1’

in software following any POR.

FIGURE 4-2:

EXTERNAL POWER-ON

RESET CIRCUIT (FOR

SLOW VDD POWER-UP)

VDD VDD

D

R

C

R1

MCLR

PIC18FXXXX

Note 1:

External Power-on Reset circuit is required

only if the VDD power-up slope is too slow.

The diode D helps discharge the capacitor

quickly when VDD powers down.

2: R < 40 kΩ is recommended to make sure that

the voltage drop across R does not violate

the device’s electrical specification.

3: R1 ≥ 1 kΩ will limit any current flowing into

MCLR from external capacitor C, in the event

of MCLR/VPP pin breakdown, due to

Electrostatic Discharge (ESD) or Electrical

Overstress (EOS).

 2004 Microchip Technology Inc.

Preliminary

DS39635A-page 51

Share Link: