STM8S105K6U3C View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM8S105K6U3C

Access line, 16 MHz STM8S 8-bit MCU, up to 32 Kbytes Flash, integrated EEPROM,10-bit ADC, timers, UART, SPI, I²C

STMicroelectronics 

Electrical characteristics

STM8S105xx

10

10.1

10.1.1

10.1.2

10.1.3

10.1.4

Electrical characteristics

Parameter conditions

Unless otherwise specified, all voltages are referred to VSS.

Minimum and maximum values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100 % of the devices with an ambient temperature at TA = 25 °C and TA = TAmax (given by

the selected temperature range).

Data based on characterization results, design simulation and/or technology characteristics

are indicated in the table footnotes and are not tested in production. Based on characterization,

the minimum and maximum values refer to sample tests and represent the mean value plus

or minus three times the standard deviation (mean ± 3 Σ).

Typical values

Unless otherwise specified, typical data are based on TA = 25 °C, VDD = 5 V. They are given

only as design guidelines and are not tested.

Typical ADC accuracy values are determined by characterization of a batch of samples from

a standard diffusion lot over the full temperature range, where 95% of the devices have an

error less than or equal to the value indicated (mean ± 2 Σ).

Typical curves

Unless otherwise specified, all typical curves are given only as design guidelines and are not

tested.

Typical current consumption

For typical current consumption measurements, VDD, VDDIO and VDDA are connected together

in the configuration shown in the following figure.

Figure 8: Supply current measurement conditions

5 V or 3.3 V

A

VDD

V DDA

VDDIO

VSS

VSSA

VSSIO

58/127

DocID14771 Rev 9

Share Link: