PIC32MX230F128L-I/PF View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC32MX230F128L-I/PF

32-bit Microcontrollers (up to 512 KB Flash and 64 KB SRAM) with Audio/Graphics/Touch (HMI), CAN, USB, and Advanced Analog

Microchip Technology 

PIC32MX1XX/2XX/5XX 64/100-PIN FAMILY

REGISTER 21-1: RTCCON: RTC CONTROL REGISTER (CONTINUED)

bit 3

RTCWREN: RTC Value Registers Write Enable bit(4)

1 = RTC Value registers can be written to by the user

0 = RTC Value registers are locked out from being written to by the user

bit 2

RTCSYNC: RTCC Value Registers Read Synchronization bit

1 = RTC Value registers can change while reading, due to a rollover ripple that results in an invalid data read

If the register is read twice and results in the same data, the data can be assumed to be valid

0 = RTC Value registers can be read without concern about a rollover ripple

bit 1

HALFSEC: Half-Second Status bit(5)

1 = Second half period of a second

0 = First half period of a second

bit 0

RTCOE: RTCC Output Enable bit

1 = RTCC clock output enabled – clock presented onto an I/O

0 = RTCC clock output disabled

Note 1:

2:

3:

4:

5:

The ON bit is only writable when RTCWREN = 1.

When using the 1:1 PBCLK divisor, the user software should not read/write the peripheral’s SFRs in the

SYSCLK cycle immediately following the instruction that clears the module’s ON bit.

Requires RTCOE = 1 (RTCCON<0>) for the output to be active.

The RTCWREN bit can be set only when the write sequence is enabled.

This bit is read-only. It is cleared to ‘0’ on a write to the seconds bit fields (RTCTIME<14:8>).

Note: This register is reset only on a Power-on Reset (POR).

DS60001290E-page 224

 2014-2017 Microchip Technology Inc.

Share Link: