PIC32MX150F256HT-I/PT View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC32MX150F256HT-I/PT

32-bit Microcontrollers (up to 512 KB Flash and 64 KB SRAM) with Audio/Graphics/Touch (HMI), CAN, USB, and Advanced Analog

Microchip Technology 

PIC32MX1XX/2XX/5XX 64/100-PIN FAMILY

TABLE 31-5: DC CHARACTERISTICS: OPERATING CURRENT (IDD)

DC CHARACTERISTICS

Standard Operating Conditions: 2.3V to 3.6V

(unless otherwise stated)

Operating temperature -40°C  TA  +85°C for Industrial 

-40°C  TA  +105°C for V-temp

Parameter

No.

Typical(3)

Max.

Units

Conditions

Operating Current (IDD) (Notes 1, 2, 5)

DC20

2

8

mA

4 MHz (Note 4)

DC21

7

13

mA

10 MHz

DC22

10

18

mA

20 MHz (Note 4)

DC23

15

25

mA

30 MHz (Note 4)

DC24

20

32

mA

40 MHz

DC25

180

250

µA

+25ºC, 3.3V

LPRC (31 kHz) (Note 4)

Note 1:

A device’s IDD supply current is mainly a function of the operating voltage and frequency. Other factors,

such as PBCLK (Peripheral Bus Clock) frequency, number of peripheral modules enabled, internal code

execution pattern, execution from Program Flash memory vs. SRAM, I/O pin loading and switching rate,

oscillator type, as well as temperature, can have an impact on the current consumption.

2: The test conditions for IDD measurements are as follows:

• Oscillator mode is EC (for 8 MHz and below) and EC+PLL (for above 8 MHz) with OSC1 driven by

external square wave from rail-to-rail, (OSC1 input clock input over/undershoot < 100 mV required)

• OSC2/CLKO is configured as an I/O input pin

• USB PLL oscillator is disabled if the USB module is implemented, PBCLK divisor = 1:8

• CPU, Program Flash, and SRAM data memory are operational, SRAM data memory Wait states = 1

• No peripheral modules are operating, (ON bit = 0), but the associated PMD bit is cleared

• WDT, Clock Switching, Fail-Safe Clock Monitor, and Secondary Oscillator are disabled

• All I/O pins are configured as inputs and pulled to VSS

• MCLR = VDD

• CPU executing while(1) statement from Flash

• RTCC and JTAG are disabled

3: Data in the “Typical” column is at 3.3V, 25°C at specified operating frequency unless otherwise stated.

Parameters are for design guidance only and are not tested.

4: This parameter is characterized, but not tested in manufacturing.

5: IPD electrical characteristics for devices with 256 KB Flash are only provided as Preliminary information.

DS60001290E-page 312

 2014-2017 Microchip Technology Inc.

Share Link: