PIC32MX150F256HT-I/PT View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC32MX150F256HT-I/PT

32-bit Microcontrollers (up to 512 KB Flash and 64 KB SRAM) with Audio/Graphics/Touch (HMI), CAN, USB, and Advanced Analog

Microchip Technology 

PIC32MX1XX/2XX/5XX 64/100-PIN FAMILY

TABLE 31-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)

DC CHARACTERISTICS

Standard Operating Conditions: 2.3V to 3.6V (unless otherwise stated)

Operating temperature -40°C  TA  +85°C for Industrial 

-40°C  TA  +105°C for V-temp

Param.

No.

Typical(2)

Max.

Units

Conditions

Power-Down Current (IPD) (Notes 1, 5)

DC40k

33

78

A

DC40l

49

78

A

DC40n 281

450

A

DC40m 559

895

µA

-40°C

+25°C

+85°C

+105ºC

Base Power-Down Current

Module Differential Current

DC41e

10

25

A

3.6V

Watchdog Timer Current: IWDT (Note 3)

DC42e

29

50

A

3.6V

RTCC + Timer1 w/32 kHz Crystal: IRTCC (Note 3)

DC43d 1000

1300

A

3.6V

ADC: IADC (Notes 3,4)

Note 1: The test conditions for IPD current measurements are as follows:

• Oscillator mode is EC (for 8 MHz and below) and EC+PLL (for above 8 MHz) with OSC1 driven by

external square wave from rail-to-rail, (OSC1 input clock input over/undershoot < 100 mV required)

• OSC2/CLKO is configured as an I/O input pin

• USB PLL oscillator is disabled if the USB module is implemented, PBCLK divisor = 1:8

• CPU is in Sleep mode, and SRAM data memory Wait states = 1

• No peripheral modules are operating, (ON bit = 0), but the associated PMD bit is set

• WDT, Clock Switching, Fail-Safe Clock Monitor, and Secondary Oscillator are disabled

• All I/O pins are configured as inputs and pulled to VSS

• MCLR = VDD

• RTCC and JTAG are disabled

2: Data in the “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance

only and are not tested.

3: The  current is the additional current consumed when the module is enabled. This current should be

added to the base IPD current.

4: Test conditions for ADC module differential current are as follows: Internal ADC RC oscillator enabled.

5: IPD electrical characteristics for devices with 256 KB Flash are only provided as Preliminary information.

DS60001290E-page 314

 2014-2017 Microchip Technology Inc.

Share Link: