DSPIC30F2012AT-20E/ML View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

DSPIC30F2012AT-20E/ML

High-Performance, 16-bit Digital Signal Controllers

Microchip Technology 

dsPIC30F2011/2012/3012/3013

7.2 Configuring Analog Port Pins

The use of the ADPCFG and TRIS registers control the

operation of the A/D port pins. The port pins that are

desired as analog inputs must have their

corresponding TRIS bit set (input). If the TRIS bit is

cleared (output), the digital output level (VOH or VOL) is

converted.

When the PORT register is read, all pins configured as

analog input channels are read as cleared (a low level).

Pins configured as digital inputs will not convert an

analog input. Analog levels on any pin that is defined as

a digital input (including the ANx pins) may cause the

input buffer to consume the current that exceeds

device specifications.

7.2.1 I/O PORT WRITE/READ TIMING

One instruction cycle is required between a port

direction change or port write operation and a read

operation of the same port. Typically this instruction

would be a NOP.

EXAMPLE 7-1:

PORT WRITE/READ

EXAMPLE

MOV #0xF0, W0; Configure PORTB<7:4>

; as inputs

MOV W0, TRISB; and PORTB<3:0> as outputs

NOP

; additional instruction cycle

btss PORTB, #7; bit test RB7 and skip if set

DS70139F-page 60

© 2008 Microchip Technology Inc.

Share Link: