CS8952(2001) 查看數據表（PDF） - Cirrus Logic
零件编号
产品描述 (功能)
生产厂家
CS8952 Datasheet PDF : 82 Pages
| |||
CS8952
BIT
NAME
TYPE
RESET
5
Auto-Neg Complete Read/Write 0
4
Parallel Detection Read/Write 0
Fault
3
Parallel Fail
Read/Write 0
2
Remote Fault
Read/Write 0
1
Page Received
Read/Write 0
0
Reserved
Read Only 0
DESCRIPTION
When set, an interrupt will be generated once auto-
negotiation has completed successfully.
Note: This bit is disabled, and writes to this bit are
ignored when the National Compatibility Mode bit of
the 10BASE-T Configuration Register (address 1Ch)
is set.
When set, an interrupt will be generated if auto-nego-
tiation determines that unstable legacy link signaling
was received.
Note: This bit is disabled, and writes to this bit are
ignored when the National Compatibility Mode bit of
the 10BASE-T Configuration Register (address 1Ch)
is set.
When set, an interrupt will be generated when paral-
lel detection has occurred for a technology that is not
currently advertised by the local device.
Note: This bit is disabled, and writes to this bit are
ignored when the National Compatibility Mode bit of
the 10BASE-T Configuration Register (address 1Ch)
is set.
When set, an interrupt will be generated if a remote
fault condition is detected either by auto-negotiation
or by the Far-End Fault Detect state machine.
Note: This bit is disabled, and writes to this bit are
ignored when the National Compatibility Mode bit of
the 10BASE-T Configuration Register (address 1Ch)
is set.
When set, an interrupt is generated each time a page
is received during auto-negotiation.
Note: This bit is disabled, and writes to this bit are
ignored when the National Compatibility Mode bit of
the 10BASE-T Configuration Register (address 1Ch)
is set.
44
CrystalLAN™ 100BASE-X and 10BASE-T Transceiver
Share Link: 