STM32L152RCY7 查看數據表（PDF） - STMicroelectronics
零件编号
产品描述 (功能)
生产厂家
STM32L152RCY7
STMicroelectronics
STM32L152RCY7 Datasheet PDF : 136 Pages
| |||
Electrical characteristics
STM32L151xC STM32L152xC
Static latch-up
Two complementary static tests are required on six parts to assess the latch-up
performance:
• A supply overvoltage is applied to each power supply pin
• A current injection is applied to each input, output and configurable I/O pin
These tests are compliant with EIA/JESD 78A IC latch-up standard.
Table 41. Electrical sensitivities
Symbol
Parameter
Conditions
LU
Static latch-up class TA = +105 °C conforming to JESD78A
Class
II level A
6.3.12
I/O current injection characteristics
As a general rule, current injection to the I/O pins, due to external voltage below VSS or
above VDD (for standard pins) should be avoided during normal product operation.
However, in order to give an indication of the robustness of the microcontroller in cases
when abnormal injection accidentally happens, susceptibility tests are performed on a
sample basis during device characterization.
Functional susceptibility to I/O current injection
While a simple application is executed on the device, the device is stressed by injecting
current into the I/O pins programmed in floating input mode. While current is injected into
the I/O pin, one at a time, the device is checked for functional failures.
The failure is indicated by an out of range parameter: ADC error above a certain limit (higher
than 5 LSB TUE), out of conventional limits of induced leakage current on adjacent pins (out
of –5 µA/+0 µA range), or other functional failure (for example reset occurrence oscillator
frequency deviation, LCD levels).
The test results are given in the Table 42.
Table 42. I/O current injection susceptibility
Symbol
Description
Functional susceptibility
Negative
Positive
Unit
injection
injection
Injected current on all 5 V tolerant (FT) pins
-5 (1)
NA(2)
IINJ
Injected current on BOOT0
Injected current on any other pin
-0
-5 (1)
NA(2)
mA
+5
1. It is recommended to add a Schottky diode (pin to ground) to analog pins which may potentially inject
negative currents.
2. Injection is not possible.
84/136
DocID022799 Rev 13
Share Link: 