ATMEGA64L-8MI View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

ATMEGA64L-8MI

8-bit AVR® Microcontroller with 64K Bytes In-System Programmable Flash

Atmel Corporation 

ATmega64(L)

Programming the EEPROM

Reading the Flash

The EEPROM is organized in pages, see Table 125 on page 296. When programming

the EEPROM, the program data is latched into a page buffer. This allows one page of

data to be programmed simultaneously. The programming algorithm for the EEPROM

data memory is as follows (refer to “Programming the Flash” on page 298 for details on

Command, Address and Data loading):

1. A: Load Command “0001 0001”.

2. G: Load Address High Byte (0x00 - 0xFF).

3. B: Load Address Low Byte (0x00 - 0xFF).

4. C: Load Data (0x00 - 0xFF).

5. E: Latch data (give PAGEL a positive pulse).

K: Repeat 3 through 5 until the entire buffer is filled.

L: Program EEPROM page

1. Set BS1 to “0”.

2. Give WR a negative pulse. This starts programming of the EEPROM page.

RDY/BSY goes low.

3. Wait until to RDY/BSY goes high before programming the next page.

(See Figure 141 for signal waveforms.)

Figure 141. Programming the EEPROM Waveforms

K

DATA

XA1

XA0

BS1

XTAL1

WR

RDY/BSY

RESET +12V

OE

PAGEL

BS2

A

G

B

C

E

B

C

E

L

0x11 ADDR. HIGH ADDR. LOW

DATA

XX ADDR. LOW DATA

XX

The algorithm for reading the Flash memory is as follows (refer to “Programming the

Flash” on page 298 for details on Command and Address loading):

1. A: Load Command “0000 0010”.

2. G: Load Address High Byte (0x00 - 0xFF).

3. B: Load Address Low Byte (0x00 - 0xFF).

4. Set OE to “0”, and BS1 to “0”. The Flash word low byte can now be read at DATA.

5. Set BS to “1”. The Flash word high byte can now be read at DATA.

6. Set OE to “1”.

2490G–AVR–03/04

301

Share Link: