ATMEGA64-16MI View Datasheet(PDF) - Atmel Corporation
Part Name
Description
Manufacturer
ATMEGA64-16MI
Atmel Corporation
ATMEGA64-16MI Datasheet PDF : 363 Pages
| |||
Power-on Reset
ATmega64(L)
Notes:
1. The Power-on Reset will not work unless the supply voltage has been below VPOT
(falling).
2. VBOT may be below nominal minimum operating voltage for some devices. For
devices where this is the case, the device is tested down to VCC = VBOT during the
production test. This guarantees that a Brown-out Reset will occur before VCC drops
to a voltage where correct operation of the microcontroller is no longer guaranteed.
The test is performed using BODLEVEL=1 for ATmega64L and BODLEVEL=0 for
ATmega64. BODLEVEL=1 is not applicable for ATmega64.
A Power-on Reset (POR) pulse is generated by an On-chip Detection circuit. The detec-
tion level is defined in Table 19. The POR is activated whenever VCC is below the
detection level. The POR circuit can be used to trigger the Start-up Reset, as well as to
detect a failure in supply voltage.
A Power-on Reset (POR) circuit ensures that the device is reset from Power-on. Reach-
ing the Power-on Reset threshold voltage invokes the delay counter, which determines
how long the device is kept in RESET after VCC rise. The RESET signal is activated
again, without any delay, when VCC decreases below the detection level.
Figure 23. MCU Start-up, RESET Tied to VCC
VCC
VPOT
RESET
VRST
TIME-OUT
tTOUT
INTERNAL
RESET
Figure 24. MCU Start-up, RESET Extended Externally
VCC
VPOT
RESET
VRST
TIME-OUT
tTOUT
INTERNAL
RESET
51
2490G–AVR–03/04
Share Link: 