MCP4014-502E/CH View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

MCP4014-502E/CH

Low-Cost 64-Step Volatile Digital POT

Microchip Technology 

MCP4011/2/3/4

6.2 Wiper Resistance

Wiper resistance is the series resistance of the wiper.

This resistance is typically measured when the wiper is

positioned at either zero-scale (00h) or full-scale (3Fh).

The wiper resistance in potentiometer-generated

voltage divider applications is not a significant source

of error.

The wiper resistance in rheostat applications can

create significant non-linearity as the wiper is moved

toward zero-scale (00h). The lower the nominal

resistance, the greater the possible error.

Wiper resistance is significant depending on the

devices operating voltage. As the device voltage

decreases, the wiper resistance increases (see

Figure 6-4 and Table 6-2).

In a rheostat configuration, this change in voltage

needs to be taken into account, particularly for the

lower resistance devices. For the 2.1 kΩ device, the

maximum wiper resistance at 5.5V is approximately 6%

of the total resistance, while at 2.7V, it is approximately

15.5% of the total resistance.

In a potentiometer configuration, the wiper resistance

variation does not effect the output voltage seen on the

terminal W pin.

The slope of the resistance has a linear area (at the

higher voltages) and a non-linear area (at the lower

voltages), where resistance increases faster than the

voltage drop (at low voltages).

RW

VDD

Note:

The slope of the resistance has a linear

area (at the higher voltages) and a non-

linear area (at the lower voltages).

FIGURE 6-4:

Relationship of Wiper

Resistance (RW) to Voltage.

Since there is minimal variation of the total device

resistance over voltage, at a constant temperature (see

Figure 2-11, Figure 2-24, Figure 2-36 or Figure 2-48),

the change in wiper resistance over voltage can have a

significant impact on the INL and DNL error.

TABLE 6-2: TYPICAL STEP RESISTANCES AND RELATIONSHIP TO WIPER RESISTANCE

Resistance (Ω)

RW / RS (%) (1, 2)

RW / RAB (%) (1, 3)

Typical

Total

(RAB)

Step

(RS)

Wiper (RW)

Typical

Max @

5.5V

Max @

2.7V

RW = RW = Max RW = Max

Typical @ 5.5V @ 2.7V

RW = RW = Max RW = Max

Typical @ 5.5V @ 2.7V

2100 33.33

75

125 325 225.0% 375.0% 975.0% 3.57% 5.95% 15.48%

5000 79.37

75

125 325 94.5% 157.5% 409.5% 1.5%

2.50% 6.50%

10000 158.73 75

125 325 47.25% 78.75% 204.75% 0.75% 1.25% 3.25%

50000 793.65 75

125 325 9.45% 15.75% 40.95% 0.15% 0.25% 0.65%

Note 1: The wiper resistance (RW) is not a significant source of error in potentiometer-generated voltage divider

applications. In rheostat applications, the variation of the RW value can create significant non-linearity.

2: RS is the typical value. The variation of this resistance is minimal over voltage.

3: RAB is the typical value. The variation of this resistance is minimal over voltage.

DS21978C-page 40

© 2006 Microchip Technology Inc.

Share Link: