TS2007FC View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

TS2007FC

3 W filter-free class D audio power amplifier with 6 or 12 dB fixed gain select

STMicroelectronics 

Application information

TS2007FC

4.7

Note:

Shutdown time

When the standby command is set to high, the time required to put the two output stages

into high impedance and to put the internal circuitry in shutdown mode, is typically 1 ms.

This time is used to decrease the gain and avoid any pop noise during shutdown.

The gain decreases smoothly until the outputs are muted (see Figure 42 and Figure 43).

4.8

Consumption in shutdown mode

Between the shutdown pin and GND there is an internal 300 kΩ resistor. This resistor forces

the TS2007 to be in shutdown when the shutdown input is left floating.

However, this resistor also introduces additional shutdown power consumption if the

shutdown pin voltage does not equal 0 V. This extra current is provided by the device that

drives the standby pin of the amplifier.

Referring to Table 2: Operating conditions on page 4, with a 0.4 V shutdown voltage pin for

example, you must add 0.4 V/300 k = 1.3 µA in typical (0.4 V/273 k = 1.46 µA maximum) to

the shutdown current specified in Table 5 to Table 9.

4.9

Single-ended input configuration

It is possible to use the TS2007 in a single-ended input configuration. However, input

coupling capacitors are needed in this configuration. The following schematic diagram

shows a typical single-ended input application.

Figure 44. Typical application for single-ended input configuration

Input

Gain select control

VCC

Cs

1uF

TS2007

GS

Cin

C1 IN-

-

Gain

A1

Select +

IN +

Cin

Vcc

PWM

OUT+ C3

H

Bridge

A3

OUT-

Speaker

Standby

Control

Oscillator

Prot ection

Circuit

Standby

Gnd

Standby control

22/28

Share Link: