STM8S007C8T6TR(2015) View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM8S007C8T6TR
(Rev.:2015)

Value line, 24 MHz STM8S 8-bit MCU, 64 Kbytes Flash, true data EEPROM, 10-bit ADC, timers, 2 UARTs, SPI, I²C

STMicroelectronics 

Electrical characteristics

STM8S007C8

9.2

Absolute maximum ratings

Stresses above those listed as ‘absolute maximum ratings’ may cause permanent damage

to the device. This is a stress rating only and functional operation of the device under these

conditions is not implied. Exposure to maximum rating conditions for extended periods may

affect device reliability.

Table 13. Voltage characteristics

Symbol

Ratings

Min

Max

Unit

VDDx - VSS Supply voltage (including VDDA and VDDIO)(1)

-0.3

6.5

Input voltage on true open drain pins (PE1, PE2)(2) VSS - 0.3

6.5

V

VIN

Input voltage on any other pin(2)

VSS - 0.3 VDD + 0.3

|VDDx - VDD| Variations between different power pins

|VSSx - VSS| Variations between all the different ground pins

-

50

mV

-

50

VESD Electrostatic discharge voltage

see Absolute maximum

ratings (electrical

-

sensitivity) on page 81

1. All power (VDD, VDDIO, VDDA) and ground (VSS, VSSIO, VSSA) pins must always be connected to the

external power supply

2. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. For true open-drain pads,

there is no positive injection current, and the corresponding VIN maximum must always be respected

44/92

DocID022171 Rev 5

Share Link: