STM8S007C8T6TR(2015) View Datasheet(PDF) - STMicroelectronics
Part Name
Description
Manufacturer
STM8S007C8T6TR
(Rev.:2015)
(Rev.:2015)
STMicroelectronics
STM8S007C8T6TR Datasheet PDF : 92 Pages
| |||
STM8S007C8
Electrical characteristics
Symbol
Table 14. Current characteristics
Ratings
Max.(1)
Unit
IVDD
Total current into VDD power lines (source)(2)
60
IVSS
Total current out of VSS ground lines (sink)(2)
60
Output current sunk by any I/O and control pin
20
IIO
Output current source by any I/Os and control pin
20
Total output current sourced (sum of all I/O and control pins)
for devices with two VDDIO pins(3)
200
ï“IIO
Total output current sourced (sum of all I/O and control pins)
for devices with one VDDIO pin(3)
100
mA
Total output current sunk (sum of all I/O and control pins) for
devices with two VSSIO pins(3)
160
Total output current sunk (sum of all I/O and control pins) for
devices with one VSSIO pin(3)
80
Injected current on NRST pin
±4
IINJ(PIN)(4)(5) Injected current on OSCIN pin
±4
Injected current on any other pin(6)
±4
ï“IINJ(PIN)(4) Total injected current (sum of all I/O and control pins)(6)
±20
1. Data based on characterization results, not tested in production.
2. All power (VDD, VDDIO, VDDA) and ground (VSS, VSSIO, VSSA) pins must always be connected to the
external supply.
3. I/O pins used simultaneously for high current source/sink must be uniformly spaced around the package
between the VDDIO/VSSIO pins.
4. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum
cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive
injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. For true open-drain pads,
there is no positive injection current, and the corresponding VIN maximum must always be respected
5. Negative injection disturbs the analog performance of the device. See note in Section 9.3.10: 10-bit ADC
characteristics on page 77.
6. When several inputs are submitted to a current injection, the maximum ï“IINJ(PIN) is the absolute sum of the
positive and negative injected currents (instantaneous values). These results are based on characterization
with ï“IINJ(PIN) maximum current injection on four I/O port pins of the device.
Symbol
TSTG
TJ
Table 15. Thermal characteristics
Ratings
Value
Unit
Storage temperature range
Maximum junction temperature
-65 to 150
°C
150
DocID022171 Rev 5
45/92
82
Share Link: 