ST72361J4-AUTO View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST72361J4-AUTO

8-bit MCU for automotive with Flash or ROM, 10-bit ADC, 5 timers, SPI, LINSCI™

STMicroelectronics 

ST72361xx-Auto

Electrical characteristics

19.3.3

Auxiliary voltage detector (AVD) thresholds

Subject to general operating conditions for TA.

Symbol

Parameter

Conditions

VIT+(AVD)

10 AVDF flag toggle

threshold (VDD rise)

VIT-(AVD)

01 AVDF flag toggle

threshold (VDD fall)

Vhys(AVD)

AVD voltage threshold

hysteresis

VIT+(AVD)-VIT-(AVD)

VIT-

Voltage drop between AVD

flag set and LVD reset

activated

VIT-(AVD)-VIT-(LVD)

1. Data based on characterization results, not tested in production.

Figure 98. LVD startup behavior

5V

VIT+

Min Typ Max Unit

4.4(1) 4.6

4.9

V

4.2 4.4 4.65(1)

250

mV

450

LVD RESET

Note:

V DD

2V

Reset state

not defined

in this area

t

When the LVD is enabled, the MCU reaches its authorized operating voltage from a reset

state. However, in some devices, the reset signal may be undefined until VDD is

approximately 2V. As a consequence, the I/Os may toggle when VDD is below this voltage.

Because Flash write access is impossible below this voltage, the Flash memory contents

will not be corrupted.

19.4

Supply current characteristics

The following current consumption specified for the ST7 functional operating modes over

temperature range does not take into account the clock source current consumption. To get

the total device consumption, the two current values must be added (except for HALT mode

for which the clock is stopped).

Doc ID 12468 Rev 3

231/279

Share Link: