ADSP-BF526BBCZ-4AX View Datasheet(PDF) - Analog Devices

Part Name

Description

Manufacturer

ADSP-BF526BBCZ-4AX

Blackfin® Embedded Processor

Analog Devices 

ADSP-BF522/523/524/525/526/527

Preliminary Technical Data

Table 10. Signal Descriptions (Continued)

Signal Name

Type Function

Driver

Type1

Power Supplies

ALL SUPPLIES MUST BE POWERED

See Operating Conditions for ADSP-BF523/525/527 on Page 29,

and see Operating Conditions for ADSP-BF522/524/526 on Page 27.

VDDEXT

VDDINT

VDDRTC

VDDUSB

VDDMEM

VDDOTP

VPPOTP

VSS

P I/O Power Supply

P Internal Power Supply

P Real Time Clock Power Supply

P 3.3 V USB Phy Power Supply

P MEM Power Supply

P OTP Power Supply

P OTP Programming Voltage

G Ground for All Supplies

1 See Output Drive Currents on Page 64 for more information about each driver type.

2 HWAIT must be pulled high or low to configure polarity. It is driven as an output and toggle during processor boot. See Booting Modes on Page 18.

3 When driven low, this ball can be used to wake up the processor from the hibernate state, either in normal GPIO mode or in Ethernet mode as MII PHYINT. If the ball is used

for wake up, enable the feature with the PHYWE bit in the VR_CTL register, and pull-up the ball with a resistor.

4 Consult version 2.1 of the I2C specification for the proper resistor value.

Rev. PrG | Page 26 of 80 | February 2009

Share Link: