Z8F041APJ020EG 查看數據表（PDF） - Zilog

零件编号

产品描述 (功能)

生产厂家

Z8F041APJ020EG

High-Performance 8-Bit Microcontrollers Z8 Encore! XP® F082A Series

Zilog 

Z8 Encore! XP® F082A Series

Product Specification

121

The baud rate is set by the UART’s Baud Rate Generator and supports IrDA standard baud

rates from 9600 baud to 115.2 kbaud. Higher baud rates are possible, but do not meet IrDA

specifications. The UART must be enabled to use the infrared endec. The infrared endec

data rate is calculated using the following equation:

Infrared Data Rate (bits/s)

=

--------S---y---s--t--e--m------C----l-o---c--k----F---r--e--q---u---e---n---c--y----(--H---z---)-------

16  UART Baud Rate Divisor Value

Transmitting IrDA Data

The data to be transmitted using the infrared transceiver is first sent to the UART. The

UART’s transmit signal (TXD) and baud rate clock are used by the IrDA to generate the

modulation signal (IR_TXD) that drives the infrared transceiver. Each UART/Infrared

data bit is 16 clocks wide. If the data to be transmitted is 1, the IR_TXD signal remains

low for the full 16 clock period. If the data to be transmitted is 0, the transmitter first out-

puts a 7 clock low period, followed by a 3 clock high pulse. Finally, a 6 clock low pulse is

output to complete the full 16 clock data period. Figure 17 displays IrDA data transmis-

sion. When the infrared endec is enabled, the UART’s TXD signal is internal to the Z8

Encore! XP F082A Series products while the IR_TXD signal is output through the TXD

pin.

Baud Rate

Clock

16 clock

period

UART’s

TXD

IR_TXD

Start Bit = 0

3 clock

pulse

Data Bit 0 = 1

Data Bit 1 = 0

Data Bit 2 = 1

Data Bit 3 = 1

7-clock

delay

Figure 17. Infrared Data Transmission

PS022827-1212

PRELIMINARY

Operation

Share Link: